COMPOUND CLOTHING

New In Store

Duis autem vel eum iriure dolor in hendrerit in vulputate velit esse molestie consequat, vel illum dolore eu feugiat
Shop Now

Latest News

 

Head Gear Wrap Installation

Items needed for your wrap installation

CK Signature Headgear
Bowl of tap water
Heatgun or blow dryer
Your Custom Wrap

Step 1

Carefully peel one sticker side off and submerge in water.

Step 2

Match up the big side of the wrap to the big side of the headgear first.

Step 3

Once the big side is on lay the rest of the sticker on going across and stretching where needed.

Step 4

Once wrap is in place and still wet make sure the center is smooth. Smooth out all of the bubbles as the water dries.

Step 5

Blow dry and smooth out edges on both sides.

(BE CAREFUL NOT TO OVERHEAT THE WRAP OF THE COLOR WILL MELT OFF)

Step 6

Heat the area around the strap holes until it begins to whither but do not over heat. Use your finger to tuck vinyl down into the strap hole for a nice finished look.

Step 7

Run over the entire headgear one last time for bubbles and possible areas that need a little more heat and you’re set to go compete!